Custom Spinning Dart Banner Flags

Use these buying points to choose the right Custom Spinning Dart Banner Flags configuration.

1. Height Matches Your Viewing Distance and Location Type

   Roadside visibility above parked vehicles needs 14 to 18 ft total height. At that range, drivers spot the flag from roughly a full block away before they reach your entrance. For parking lot islands and event entrances where people are on foot, 10 to 12 ft keeps the flag readable without overwhelming the space. Pick your height in the configurator before uploading your design, because the dart silhouette proportions shift at each height.

2. Single-Sided Versus Double-Sided Print

   Single-sided works for most roadside setups where traffic approaches from one primary direction. Your design prints on the front and shows through as a mirror image on the reverse at about 80 percent visibility.

   But if your flag sits on a roundabout, parking lot island, or corner lot where people approach from two or more directions, order double-sided. Double-sided uses two printed layers with a blockout layer (a white barrier between the two sides) so both sides carry a clean, independent image. Add double-sided at checkout before submitting your proof.

3. Base Selection Depends on Your Surface

4. Grass, Soil, or Dirt Lots

   Choose the steel ground spike. It pushes into soft ground in seconds and holds the pole steady in moderate wind.

5. Concrete, Asphalt, Pavers, or Indoor Floors

   Choose the steel cross base with a water bag filled to 15 to 20 lbs. That weight keeps the flag stable on hard surfaces without drilling. Do not guess here: the wrong base on the wrong surface will not hold the flag steady when wind hits.

6. Spinning Dart Versus a Fixed Flag Shape

   Traffic approaching from two or more directions is the main reason to choose the spinning dart. You cannot manually reposition the flag during the day, and a fixed feather or teardrop flag faces one direction and relies on flutter for motion. The dart rotates to face each direction automatically. That said, if your location has a single traffic lane, a feather or teardrop flag gives you more printable area at the same height.

Worth knowing: the flag spins, so keep text large and layouts simple. Fine print does not read from a moving vehicle at any resolution.

Accepted formats

PDF, PNG, JPG, AI. Vector files (AI or PDF) work best for logos because they scale to any flag height without losing edge clarity.

Resolution

150 DPI minimum at final print size. Go to 300 DPI for any flag under 10 ft, because viewers standing within 5 to 8 ft will catch a soft edge that looks fine on screen.

Bleed

0.25 in on all sides. Bleed is the extra artwork that extends past the cut line so no white edges appear after trimming.

Safe zone

Keep all text and logos at least 0.5 in inside the dart silhouette edge. The dart shape tapers at the tip, so anything close to that edge risks getting cut off.

Color mode

CMYK, not RGB. CMYK (cyan, magenta, yellow, black) is the four-color process we print with, so colors you see on screen match what comes off the press. RGB files shift in ways that can make your brand colors print warmer or cooler than expected.