Custom Blade Flags

Use these buying points to choose the right Custom Blade Flags configuration.

1. Matching Your Mounting Base to the Installation Surface

   The surface under your flag determines which base you need. Steel ground spikes push into grass, soil, or packed dirt by hand in under a minute. No tools needed. For concrete, asphalt, pavers, or indoor floors, the steel cross base sits flat and pairs with a water bag (fillable to 15 to 20 lbs) so the pole stays planted without drilling. Worth knowing: you do not need separate hardware for each location. One flag kit moves between a grassy entrance and a hard-surface expo floor by swapping the base. Match the base to your actual surface, then add it in the configurator.

2. Selecting the Right Flag Height for Your Viewing Distance

   Height is a visibility decision, not an aesthetic one. For sidewalk placement or entrance positions where people pass within 6 to 8 ft, an 8 to 10 ft blade flag puts your logo at eye level and just above. That range suits restaurants, salons, and real estate open house curb markers.

   For parking lot rows or roadside locations where drivers need to spot the flag above parked vehicles, 12 to 16 ft is the practical range. At that height, the straight blade silhouette reads as a clean vertical column from roughly 40 to 50 ft away. Select your height in the configurator and the matching pole kit ships with the flag.

3. Deciding Between Single-Sided and Double-Sided Printing

   Single-sided works when your flag faces one clear primary direction. A flag angled toward oncoming traffic on one side of a driveway is a good single-sided candidate. Your design prints on the face and shows through at roughly 80 percent opacity on the reverse. That's fine when the back faces a wall or a lane without foot traffic.

4. When Double-Sided Is Worth the Added Cost

   Double-sided printing uses two fully printed panels with a blockout layer between them, so both sides read correctly with no mirror image. Choose double-sided when vehicles or pedestrians approach from both directions and a reversed logo would create confusion. Busy parking lot entrances and trade show aisle corners are the clearest cases for the upgrade. Select double-sided in the configurator before you upload artwork, since the two panels need to be set up as separate files.

Custom Blade Flags run full CMYK color on every order, so gradients, photography, and multi-color logos all reproduce without limits. But the file you send in determines how sharp the final print looks on the fabric.

Accepted formats

PDF, PNG, JPG, AI. Vector files (AI or PDF) work best for logos because they scale without losing edge sharpness.

Resolution

150 DPI minimum at final print size. For flags under 8 ft where viewers get within 5 to 8 ft, 300 DPI keeps edges crisp rather than soft.

Bleed

0.25 in on all edges. This covers any slight shift during finishing.

Safe zone

Keep logos and text 0.5 in from the sleeve edge and flag tip. The blade shape tapers toward the top, so place your primary logo within the widest section of the flag face for full readability.

Color mode

CMYK, not RGB. RGB files convert during processing and colors can shift. Sending CMYK means what you see on screen matches what bonds into the fabric.