The products are currently not available!
Custom Tension Fabric Trade Show Booths - FAQ
Minor fold lines can appear after transit. But once you stretch the fabric onto the frame, the silicone-beaded edge pulls the graphic taut and most wrinkles disappear within a few minutes on their own. Steam out any stubborn lines with a handheld steamer before setup. Fabric recovers from folding far better than vinyl, which holds curl memory from rolling and rarely lays flat without heat treatment.
Yes, and it's straightforward. Machine wash cold with mild detergent, tumble dry on low. The dye sublimation process bonds ink permanently into the polyester fibers rather than sitting on the surface, so the print does not crack, peel, or fade through repeated washing. Do not bleach or iron directly on the printed side.
Contact us immediately. Our aluminum frame carries a lifetime hardware warranty, so broken tubes and connectors are covered. For fabric damage, replacement panels ship in 2 to 3 business days. Honestly, keeping one spare connector set in your carry case is worth it for back-to-back shows where there's no time to wait on shipping.
The short answer: it depends on your reuse plan. Exhibitors attending 4 or more shows per year recover the investment quickly because the aluminum frame and accessories last indefinitely. For 1 to 2 shows per year, the math still works if you swap fabric graphics each cycle rather than buying a new kit. Replacement panels run a fraction of the full booth cost, so the hardware pays for itself over 2 to 3 cycles.
Fabric wins on three points that matter at a show. No glare under convention hall lighting, machine-washable between events, and folds flat into a carry bag instead of rolling into a tube. Vinyl reflects overhead fluorescent lights and causes hot spots in photos. Dye sublimation on 210 to 230 GSM polyester reproduces gradients and photographic imagery more consistently than vinyl printing, and the matte finish reads evenly from any angle.
